How to review a warning/critical/unknown error in the web interface?

QUESTION:

How to review a warning/critical/unknown error in the web interface?

 

RESOLUTION:

This guide will show the steps to check the warning/critical alarm.

 

1. In Traverse go to Status > Devices

2. Click to focus on the affected device. As shown in the image below "ESXi"

3. Click on the "hand" icon next to the alarm (highlighted)

check_error1.JPG

4. A pop-up window will show up the error corresponding to that warning/critical message as shown in the image below

check_error2.JPG

 

APPLIES TO:

All versions of Traverse

Have more questions?

Contact us

Was this article helpful?
0 out of 1 found this helpful

Provide feedback for the Documentation team!

Browse this section